Daily Wear Application

Topside Application

Great for people with

  • Eyelash Extension who need to fill a little gap while waiting for their next appointment.
  • People with very thin or sparse lashes.
  • Sensitive Eyes.

STEPS

  1. Prep lashes by making sure they are clean and NOT oily from makeup remover or remover wipes. Pro Tip: We like to use a lash wash, or a witch hazel toner to make sure they are squeaky clean!
  2. Shake the Adhesive Liner for 10 seconds. 
  3. Apply 2-3 thin coats at the base of your lash line (like eyeliner).  Pro Tip: On coat 2 and/or 3 just press liner in like a stamp instead of gliding it.  Pay extra attention to the inner and outer corners. 
  4. On your last coat gently swipe the tip of the liner over the top of your lashes.  Pro Tip:  If you have really blonde lashes, you might like the black or brown liner for this step.
  5. Use tweezers to pick up the inner “flutter” and place on the liner at the same angle of your natural lashes.  If you didn’t get it in the right spot the first time and the flutter isn’t sticking, just add a bit more adhesive liner in that area.
  6. Apply the remaining flutters next to the previous ones at the same angle.  Pro Tip: Just trim the last section in half if it is too long for your eye.
  7. Use your tweezers to gently squeeze the flutters and your natural lashes together.
Underside Application

Great for people with

  • Normal to thick lashes and NO extensions
  • Hooded eyelids

STEPS

  1. Prep lashes by making sure they are clean and NOT oily from makeup remover or remover wipes.  Pro Tip: We like to use a lash wash, or a witch hazel toner to make sure they are squeaky clean!
  2. Apply the Adhesive Liner onto the natural lashes just like you would apply mascara, paying extra attention to the inner and outer lashes.  Apply 2-3 coats.
  3. Place your flutter sections on the makeup sponge. Gently press the adhesive liner down onto the base of the flutters to coat them. Repeat this 3x for the first application.  Pro Tip: Applications after the first time will only need a small amount of adhesive on the flutter sections, if any at all.
  4. Start with the inner eye, use tweezers to pick up the flutter and place underneath your lashes. (Be sure to not place them too close to the nose or it will be uncomfortable). You are attaching the flutter to your natural lashes, not on your waterline or close to your eyeball. Gently press up against your natural lashes so the flutter adheres.  Pro Tip: If you are not able to get the flutter to stick to your natural lashes, first try adding a bit more adhesive liner to your natural lashes and then add another coat to the base of the flutter.  
  5. Repeat for each section of the eye.  Pro Tip: Trim the last piece with scissors if needed for a perfect fit.
  6. Once your lashes are applied, swipe the inside of the tweezer with our Sticky Fix Sealant and squeeze each flutter section to your natural lashes.
Removing Lashes
  • With your tweezers, gently grab each flutter and pull away from your natural lashes. They should come off very easily! Place each section back in your case for your next application.
  • If you have Adhesive Liner residue on your eyelid or natural lashes, gently rub the area with remover. Once you have wiped away any residue, wash your lashes with your favorite lash wash!  Pro Tip: If you have extensions on, only apply the cleaning oil where necessary and wipe up and away from the lashes with your lint free applicator. 
Cleaning Your Lashes

Note: Do not wash the Limited-Edition lashes, they will need to be replaced after 10-15+ uses.

  • Place the lashes inside the lid of our 3-in-1 Spray Cleaner.  Spray them a few times until well coated.  Let sit anywhere from 5 min to overnight. 
  • Using your tweezers or fingers, wipe away residue, rinse and pat dry.
  • Place them back in your lash compact for your next application.